DANFOSS EKC 201 PDF

FFT10 interface or RS interface. For. For. EKC EKC For. For .. Danfoss can accept no responsibility for possible errors in catalogues, brochures . Introduction. Features. EKC (for panel mounting) and EKC EKC and are used for. • temperature Danfoss Pt sensors are supplied with . Danfoss EKC – Download as PDF File .pdf), Text File .txt) or read online.

Author: Mirr Kalkis
Country: Great Britain
Language: English (Spanish)
Genre: Career
Published (Last): 11 June 2016
Pages: 237
PDF File Size: 12.56 Mb
ePub File Size: 9.32 Mb
ISBN: 418-2-51893-948-2
Downloads: 10104
Price: Free* [*Free Regsitration Required]
Uploader: Grolmaran

The time delay is set in minutes. EKC12 V: When a data communication module is mounted, the controller may be fitted with a Danfoss gateway type AKA The importance is defined with the setting: It will collect temperature values, and it dafnoss receive alarms.

If SPST is cut out, alarm rkc starts and the fan is stopped, cf. The controller comes prepared with plug and terminals, so all you have to do is to push the module into place. In the event of error function, the actual parameter code can be displayed.

Defrost sensor Here you can set whether a defrost sensor has been mounted. Alarm relay not activated Room temp.

Controller for temperature control – EKC 201 and EKC 301 Manual

If a module with data communication is mounted, the controller can send the status of the switch function to the data communication network. Push the lower button Set of a menu 1. In controllers with a defrost relay you can set whether the defrost is to be made with electricity or hotgas.

Time-controlled hot gas defrost. They mean the following: Room temperature control by pump down.

Danfoss Temperature Controller Electronic Controller Ekc 201

Power on Room temp. OFF or you set an inter val. ON-time c01 0 min 15 min 0 min Min. Defrost method Here you set whether defrost is to be accomplished with electricity or hotgas. Fitting the EKC controller with a plug-in module for communication gives access to all parameters of the controller.

Defrost Defrost The controller contains a timer function, so that danofss defrost can star t periodically, e. Ealarms will however be visible as soon as the defect occurs. All alarms are indicated by the three LEDs flashing at once. If you push the top button in this situation, you will be able to see the alarm message in the display.

It will cut out again when the temperature drops to the set reference value. Upper deviation Here you set when the alarm at high temperature is to become activated. Real time clock battery driven can be fitted.

Danfoss Electronic Controller (EKC EKC ) –

The display shows the actual room temperature, but by activating the keys the display changes To the set or the actual temperature of the defrost sensor. OFF-time Safety function in connection with sensor errors If the room sensor becomes defective is shor tcircuited or cut outthe controller will star t a regulating frequency of the compressor at the same time as an alarm is sounded for the sensor error.

The time when water drips off the evaporator.

The controller has been specially designed for refrigeration applications, but may of course also be used for other forms fkc regulation where this is expedient. Example Each controller is provided with an insertion module.

Afterwards the controller is capable by itself to calculate the average value of previous cut-in times. During and immediately after a defrost the display will show the temperature measured just before defrost was star ted.

A door switch is connected and the controller will register when the DI input is open. If you have chosen stop based on time, this setting will be the defrost time.